Our detailed Instruction Booklet explains how Parkerizing works and takes you through the process step-by-step with plenty of helpful trouble shooting info. I’m going to use directions specific to the phosphate solution I’m used to .. I’ve done this using the manganese solution off of brownells, it pit a. Parkerizing – Products. Parkerizing Instructions · PARKERIZING SUPPLIES ONLY · BROWNELLS. Unfortunately, this product cannot be ordered. Parkerizing.
||18 December 2004
|PDF File Size:
|ePub File Size:
||Free* [*Free Regsitration Required]
I’ve looked at them, finish ranges from bad to meh.
Pistol Irons Glass Milsurp. The hunt is on, anyway. When I was function testing it I had it covered in cold blue just to keep it from rusting up on me, so I guess I could take that as a baseline. Add Phosphate Solution Instructiions your phosphate solution to the correct proportion. If you have an air compressor, blow it off.
It was more than ten steps. Log in or sign up in seconds. Leave the parts in the bath for minutes, until gassing that’s bubbles stops. I read right over that. Put your parts in the bath, ideally on some sort of rack or hanger that will make sure the entire part gets done.
But do it anyway, because I said so. I did park the whole frame and slide. Part Prep In this step, make sure you plug anything that isn’t going to be phosphated. Remember, this might vary.
As usual, you are correct. No links to sweepstakes No links to opinion blogs No open-ended questions: Once time is up, remove the parts and move on to Step 9 finally. Please read the rules, the FAQand search before posting.
An easy way to do this is with parketizing pool pH stuff you can buy at Wally World. Is the coating thick enough to affect fitment?
Ten Easy Steps to Parkerizing Your Gun Parts at Home : guns
Yes, another rinse step. Many so-called paroerizing are doing instructinos less rigorous version of what I have posted here. Of all the things to have a professional job done on, your gun’s finish seems like one. No conducting firearms-related transactions. I even lube lol hypocrisy my bike chain with it if I’ve got nothing else around. There are several rinsing steps, and they are perhaps the most crucial to getting a consistent and blemish-free end-product. Wipe off any excess oil, clean up your shit, and dispose of all chemicals according to federal, state, and local law.
WD isn’t a lubricant, but that’s not what you’re using it for here. Want to add to the discussion?
Toss some scrap iron, iron chips, or steel wool into the basin. You’re not really adding much to the surface of the part since it’s not really a coating. Phosphate That Shit You heard jnstructions.
No direct links to products for sale No surveys, polls, GoogleDocs etc without pre-approval. Parkerizing is more wear parkerizinh than Duracoat. If it’s a frame, take all the parts out. At least with distilled water the mineral content is practically 0 compared to your normal tap water this is especially true if you live in an area with hard water. Since Parkerizing is done through immersing the parts in a solution bath, I’m not sure how one would go about not coating the rails, but it didn’t really effect theCZ or brrownells I have done.